Advertisement
1
Preparing the Mower
No Parts Required
Procedure
Note:
Determine the left and right sides of the
machine from the normal operating position.
1.
Park the machine on a level surface.
2.
Disengage the drives and the power take-off.
3.
Shut off the machine and remove the key.
4.
Wait for all moving parts to stop.
5.
Electric models only: turn the
battery-disconnect switch to the O
position.
6.
Thoroughly clean the mower deck. Remove
all debris to ensure that the baffles fit properly
against the mower deck.
7.
Repair all bent or damaged areas of the mower
deck and replace any missing or damaged parts.
2
Opening the Engine Guard
and Removing the Guard
Extension (Gas Models
Only)
No Parts Required
Opening the Engine Guard
1.
Remove the bolt and shoulder nut securing the
engine guard to the guard extension
1. Bolt and shoulder nut
FF
2.
Rotate the engine guard forward as shown in
Figure
(Figure
1).
Disconnecting the Spark-Plug
Wire
Remove the spark-plug wire from the spark plug.
3
Figure 1
2. Engine guard
2.
Figure 2
g279539
g279542
Advertisement
