Table of Contents
Advertisement
Empty the condensation water container
When the drying program has ended
or the display shows a message
during operation, empty the
condensation container.
requirements
¡After drying, the display shows
nen: "End"
¡or the display shows during
of the company: .
Pull out the condensation water
1.
container horizontally.
Empty the condensation water
2.
container.
Check the condensation water
container filter regularly
→ Page 46 and clean a dirty filter.
Make sure the condensation
water container
of the device
→ "condensation
push", page 37
the company
hit.
container insert
Condensation container
push in
Push the condensation water
▶
container in as far as it will go.
1 3 Parental Controls
S
secure your device against an insured
Visible operation of the controls.
13.1 Activate parental controls
On
3 sec.approx. 3 seconds
▶
press.
aThe controls are locked. aThe parental
controls also remain in place
Ready state (standby) of the device
and active in the event of a power
failure.
13.2 Deactivate parental
controls
Requirement:To deactivate parental
controls, the device must be switched
on.
On
3 sec.Press for approx. 3
▶
seconds.
Parental controlsde
37
Advertisement
Table of Contents
