Sony Cyber-shot DSC-RX0M2 Service Manual page 16

2019/05/15 01:58:50 (GMT+09:00)
Self-diagnosis Code
Repaired
by: Function
E 61
E 62
E 62
E 62
E 62
E 62
E 91
E 92
E 94
E 95
E 95
E 95
*1: Function of this code is not provided in this unit.
Block Detailed
Code
30 *1 Reset position detection error on the
stepper iris initializing
02 *1 Abnormality of IC for steadyshot.
10 *1 Shift lens initializing failure
11 *1 Shift lens overheating (PITCH)
12 *1 Shift lens overheating (YAW)
20 Abnormality of thermistor
01 *1 Abnormality when flash is being
charged
00 Battery/Dry cell distinction defect
00 *1 Fault of writing or erasing the
internal memory
00 *1 GPS hardware error
01 *1 Acceleration sensor hardware error
02 *1 Electronic compass hardware error
(GPS hardware error)
Symptom/State
Turn the power on to open lens barrier. Disconnect the
battery or power cord, and then connect again. And
confirm that the iris blades in lens are working.
If iris blades do not work, check the iris motor drive
circuit in lens drive block. If iris blades work normally,
confirm that they are closing completely and confirm
following items.
•
Case of the iris blades do not close normally. Replace
the lens block.
•
Case of "E: 61: 30" is appeared and iris blades closed
completely. Confirm that communication with lens block
is normal.
•
Case of LCD is not displayed normally, check that
connection between imager board and main board.
•
Case of LCD is displayed normally, replace the lens
block.
Check signal line connections from CPU through
steadyshot IC to PITCH/YAW drive.
When there is no problem with the connections, replace
the board that contains this peripheral circuit.
Replacement of lens block.
If an error occurs again, steadyshot circuit may be faulty.
Replace the board that contains this peripheral circuit.
Check signal line connections from CPU through
steadyshot IC to PITCH/YAW drive.
When there is no problem with the connections, check
whether this error is due to the lens or the board.
Replace the faulty lens or board.
Check signal line connections from CPU through
steadyshot IC to PITCH/YAW drive.
When there is no problem with the connections, check
whether this error is due to the lens or the board.
Replace the faulty lens or board.
Check signal line connections from CPU through
steadyshot IC to PITCH/YAW drive.
When there is no problem with the connections, check
whether this error is due to the lens or the board.
Replace the faulty lens or board.
Checking of flash unit or replacement of flash unit.
Turn power off and turn power on again.
The internal memory (CPU) may be faulty.
Replace the board that contains this peripheral circuit.
Check the signal line connection for GPS.
When there is no problem with the connections, replace
the board that contains this peripheral circuit.
Turn power off and turn power on again.
When this error is not cleared, the peripheral circuit of
the acceleration sensor may be faulty.
Replace the board that contains this peripheral circuit.
The peripheral circuit of the electronic compass may be
faulty.
Replace the board that contains this peripheral circuit.
Sony CONFIDENTIAL
For Authorized Servicer
Correction
8
SYS SET