Program example [FX5-SSC-G]
The following shows a sample program of executing synchronous control on the axis 1 with the axis 4 as an input axis using
the 4-axis module. (The axis 4 is configured as the virtual servo amplifier.)
1.
On the "CC-Link IE TSN" screen, set MR-J5-G for station No. 1 and 2, then set station No.1 and station No.2 as axis 1
and axis 4, respectively, on the "Parameter" screen.
2.
Set the axis 4 as the servo input axis in the "Input Axis Parameter" window.
Appendix 2 Sample Program of Synchronous Control
A
APPX
185