Samsung AM CNB C AA Series Technical Data Book page 58

13. Installation
Power supply and communication cable configuration
▶ Withdraw a main power cable and a grounding cable through the cable outlet on the right side of the
DVM Hydro unit / Hydro unit HT.
▶ When connecting external contact signal wire, connect them to the PCB terminal board through the cable
outlets in the right side of the outdoor unit.
▶ Wires must be installed after putting them in separate conduit tubes.
▶ Fix the conduit at the cable outlet using a conduit adapter.
Main PCB
Power cable terminal board
Power cable (Fix it to the clamp
on the bottom of the terminal
Control kit
Power cable Terminal board
board)
Main PCB
Wired remote controller wiring
DVM Hydro unit • Outdoor unit
communication cable
Conduit adapter
Conduit
Wired remote controller wiring
DVM Hydro unit HT+Outdoor
unit Communication cable
Conduit adapter
Conduit