Display Functions - PEUGEOT CITYSTAR Owner's Manual

NOTICE_CTS_EURO4_V3-04A.mif Page 11 Lundi, 6. mars 2017 10:27 10

DISPLAY FUNCTIONS

J A B
H
8
G F
A.Outside temperature gauge.
-The temperature shown is that
v read on the front of the vehicle.
-The "risk of black ice" symbol
comes on as soon as the
temperature falls below3°C (v).
B.Battery charge indicator.
- If the battery charge indicator flashes while driving you
are advised to have the vehicle checked by an
authorised dealer.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters
C.Engine temperature gauge.
The operating temperature is
indicated by the display of 6
segments. The minimum and
maximum temperatures are
indicated by the letters C and H.
The high temperature warning is
indicated by the 6 segments
t
flashing simultaneously with the
"temperature" symbol (t) and the
C
letter H. You are advised to switch
of the engine and check the coolant
level after it has cooled down. If the level is correct, have
D
the vehicle checked by an approved dealer.
E
D.Clock.
The clock can only be adjusted in the odometer position
using the settings button (8).
• Pressing the settings button for longer than 3 seconds
causes the two figures for the hours to flash.
- Set the time by successive pushes on the control
button.
• Pressing the settings button for longer than 3 seconds
causes the tens figure for the minutes to flash.
- Change the tens figure for the minutes by successive
presses on the settings button.
• Pressing the settings button for longer than 3 seconds
causes the units figure for the minutes to flash.
- Press the settings button for more than 3 seconds to
validate the clock setting.
E. Milometer.
- The tripmeter displays and stores the number of
kilometres travelled by the vehicle. The machine total
kilometres remains in the memory when the battery is
disconnected.
F. Tripmeter (TRIP).
- The tripmeter displays and stores the number of
kilometers travelled during a given period.
- The vehicle's trip meter remains in the memory even
when the battery is disconnected.
Resetting the tripmeter.
- With the ignition switched on, the trip meter can only
be reset by pressing the settings button (8) for longer
than 3 seconds.
Choosing the display units
Choosing the distance unit is possible at any
time.
-With the ignition off,
hold down the settings
button (8), switch on the
ignition and wait for the
multifunction display to
come on.
-Select the unit by briefly
pressing the control
button, the distance unit
changes from "km" to
"miles" or inversely.
- Turn off the ignition.
If the distance unit is kilometres, the outside
temperature is displayed in °C. The autonomy
indicator is in L/100 km.
If the distance unit is miles, the outside
temperature is displayed in °F
FR
GB
DE
IT
ES
NL
GR
SE
PT
FI
DK
11/25