Advertisement
STEPS
TOP FRAME ASSEMBLY
PART NAME _ f
{ 160
5/16" FLAT WASHER
51
5/16" NYLON LOCK NUT
55
5/16" X 2 3/4" HEX HEAD BOLT
68
5/16" X 1/2" HEX HEAD BOLT
81
2" SQUARE PLASTIC INSERT САР
140
5/16" X 4 3/4" HEX HEAD BOLT
141
2" X 4" PLASTIC INSERT CAP
[C] Press
a2" SQUARE PLASTIC INSERT CAP (81) into the front of the
TOP FRAME
(15).
Press a 2" X 4" PLASTIC
INSERT CAP
(141)
into the back of the Top Frame.
(0 Assemble the TOP FRAME (15) to the top of the FRONT UPRIGHT
(10) and the REAR UPRIGHT (3). Align boll holes and place the
Rear Upright into the Welded Brackets of the Top Frame and the
Guide
Rods
into the Welded
Cross-member
Bracket
of the
Top
Frame.
C] Assemble the GUIDE RODS (17) to the Welded Cross-member Bracket of the TOP FRAME (15) by inserting 5/16" X 1/2"
HEX HEAD BOLTS (58) into the open slot at the top and on the inside of the Guide Rod.
Insert the Bolts one through
each side of the Guide Rod and then through the Bracket. Fasten with a 5/16" NYLON LOCK NUT Г (51) but tighten only
L] Attach the FRONT
to the TOP. FR
assembling
WASHERS (50) onto two 516" x
top of the Top Frame and into the
Welded Bracket of the Upright.
Fasten with 5/16" NYLON LOCK
7 NUTS (61) but tighten only finger
tight at this time.
(0 Assemble the REAR UPRIGHT (3)
to the TOP FRAME (15) by bolting
with a 5/16" X 2 3/4" HEX HEAD
BOLT (55) through the Welded
, Bracket of the Top Frame an then
through ihe Upright. Secure with a
5/16" NYLON LOCK NUT (51).
О
Take the time now (о tighten ай the-
-Bolts .that were. previously left
ы
імен іп this step. ў
ж) Бешоүе` the POWER 'GUIDE
`
' DECAL .(100): from thé -backing
sheet and affix to both sides-of the: ~.
TOP MAST (15). .
finger tight at this time. (SEE DETAIL A)
LT:
(1
К
and then bolting 'down 'through the
DETAIL A
Advertisement
