Advertisement
AV-32WP2EN
AV-32WP2EP
REMOVING THE CRT
*Replacement
of the CRT
should
be performed
by 2 or more
persons.
»
After removing the cover, chassis etc..,
1. Putting the CRT change table on soft cloth, the CRT change table
should also be covered with such soft cloth (shown in Fig.3).
mae
i:
H Y
APPROX.
2. While keeping the surface of CRT down, mount the TV set on the
Gi
x
Y
CRT change table balanced will as shown in Fig.4.
3. Remove 4 screws marked by arrows with a box type screw driver as
shown in Fig.4.
»
Since the cabinet will drop when screws have been removed,
be
sure to support the cabinet with hands.
4. After 4 screws have been removed, put the cabinet slowly on cloth
(At this time, be carefully so as not to damage the front surface of the
cabinet) shown in Fig.5.
»
The CRT should be assembled according to the opposite sequence
of its dismounting steps.
*
The CRT change table should preferably be smaller that the CRT
surface, and its height be about 35cm.
CRT CHANGE TABLE
COATING OF SILICON GREASE FOR ELECTRICAL
INSULATION ON THE CRT ANODE CAP SECTION.
»
Subsequent to replacement of the CRT and HV transformer or repair
of the anode cap, etc. by dismounting them, be sure to coat silicon
grease for electrical insulation as shown in Fig.6.
Wipe around the anode button with clean and dry cloth. (Fig.6)
Coat silicon grease on the section around the anode button. At this
time, take care so that any silicon greases dose not stick to the
anode button. (Fig.7)
* Silicon grease product No. KS - 650N
diameter of
anode cap.
coating
silicon grease)
of silicon grease
Anode cap
Fig. 6
Fig. 7
8
J0.51237
Advertisement
