Advertisement
AV-32WP2EN
AV-32WP2EP
DEFLECTION CIRCUIT ADJUSTMENT
There are 3 modes of the adjustment
(1) 50Hz mode
( PANORAMIC
@FULL @SUBTITLE ), ( 2 ) 60Hz mode ( each aspect
mode)
--:---
depending upon the kind of signals ( vertical frequency 50Hz / 60Hz ).
When the 50Hz PANORAMIC mode has been established, the setting of other modes will be done automatically.
However, if the picture quality has not been optimized, adjust each mode again, respectively.
@
The adjustment using the remote control unit is made on the basis of the initial setting values.
@
The setting values which adjust the screen to the optimum condition can be different from the initial setting values.
Regular and Zoom switching is conducted not by the Deflection circuit, but by the 100 Hz PWB. Therefore, the deflection
system cannot be adjusted in these modes.
|
Initial setting value
Setting item
Adjustment name
PANORAMIC
FULL
soriz | 6oHz |
| sonz | soz | cor
0
1.V-SLOPE
Vertical def. Start position
2.V-SHIFT
Vertical center
3.V-SIZE
Vertical height
4.H-CENT
Horizontal center
idth
8. TRAPEZ
Trapezoidal distortion correction
9.V-S.CR
Vertical height correction
10.EHT-COMP
| Size Regulation
\
{
7.EW-COR
Side pin four corner correction
|
11.CLAMP
CLAMP Position
No.51237
25
Advertisement
