Advertisement
AV-32WP2EN
AV-32WP2EP
Adjustment of | Remote
P. CW TRANSF.
®@ Do not make any adjustment unless the adjustment is out of
control unit
(T7103)
way and you cannot get correct PICTURE.
P.L-VL CW TRIM C
.
Select 1.IF from the SERVICE MENU.
(C122)
.
Press 1 key and select 1.VCO.
[In P&P PWB]
.
Press OK key and select " VCO (CW) = SUB ".
Select a receivable broadcast channel with the CHANNEL key.
Turn the core of P. CW
TRANSF.
until the colour of the
characters TOO HIGH displayed on the screen changes from
blue to_ Yellow. (Step 1)
Turn the core of P. CW
TRANSF.
until the colour of the
characters TOO LOW changes from blue to Yellow. (Step 2)
Then slowly turn back the core of P. CW TRANSF. until the
colour of the characters JUST REFFERENCE
changes from
blue to Yellow. (Step 3)
In the district SECAM L broadcast channel with the CHANNEL
key and adjust the P.L-VL CW TRIM. C in same manner as for
above step. And necessary, readjust P. CW. TRANSF.
Press the INFORMATION
key three times to return to normal
screen.
. Perform CHANNEL
PRESET again, and make sure that each
broadcast is being received properly.
Adjustment of | Remote
NOISE VR
.
Set to 2 screen mode.
DELAY POINT | contro! unit
(R137)
.
Receive black and white signal on the right screen.
Adjust the NOISE VR (R137) to eliminate noise from the right
screen.
18
No.51237
Advertisement
