Table of Contents
Advertisement
beginning.
●
In the following situations, ID code
registration will not be started or
was not completed properly and
the system will not operate prop-
erly. Perform the ID code registra-
tion procedure again.
• If, when attempting to start ID
code registration, the tire pressure
warning light does not blink slowly
3 times.
• If, when the vehicle has been
driven for about 20 minutes after
performing ID code registration,
the tire pressure warning light
blinks for approximately 1 minute
and then illuminates.
●
If ID code registration cannot be
completed after performing the
above procedure, contact your
Toyota dealer.
MIRAI Owners Manual_USA_M62034_en
7-3. Do-it-yourself maintenance
Replacing the tire
When raising your vehicle
with a jack, position the jack
correctly.
Improper placement may
damage your vehicle or
cause injury.
If necessary tire replace-
ment seems difficult to per-
form, contact your Toyota
dealer.
Before jacking up the
vehicle
Stop the vehicle in a safe
place on a hard, flat surface.
Set the parking brake.
Shift the shift position to P.
Stop the fuel cell system.
■
Jack and tools
As your vehicle is not installed spare
tire, the following tools for replacing
a tire are not included with your
vehicle. They can be purchased at
your Toyota dealer.
●
Wheel nut wrench
●
Jack
●
Jack handle
413
7
Advertisement
Table of Contents
