Table of Contents
Advertisement
PAGE
11
WEIDER SPORTING GOODS
Fit a FLAIR END BUSHING
(94) (flair end to the inside) |
onto the 5/8" Cylinder Pivot
Tube
on
the
REAR
UPRIGHT (3).
ГІ Side
а
RESISTANCE
CYLINDER
(7) over
the
Cylinder
Pivot
Tube
and
secure in place with а 5/8"
SPRING
RETAINER
RING
(98). Again the teeth of the
Retainer
Ring
should
be
positioned outward and use
the 5/8" ROUND
PLASTIC
COVER CAP (83) as an aid
to help secure the Retainer
Ring in place.
Tap this Cap
and Retainer Ring on using
a hammer.
(О то the bottom end of the
RESISTANCE CYLINDERS
(7), attach the CYLINDER
MOUNTING BRACKET (9)
with
a 5116" X 1 1/2" HEX
HEAD BOLT (53) and 5/16"
NYLON LOCK NUT (51).
О
Insert
the
bolt
on
the
CYLINDER
MOUNTING
BRACKET
(9) into one of
the holes in the STEPPER
PEDALS (5) and secure in
place
with
a
3/8"
FLAT
WASHER
(60) and a 3/8"
FEMALE KNOB (99).
»
NOTE:
There are seven hole
location
іп
the
STEPPER
PEDALS
(5).
The Stepper
resistance increases as the
Cylinder is moved toward the
end
of the Pedal.
C] Remove
the STEPPER
STATION
DECAL
(101)
from the backing sheet and
apply
to
the
REAR
UPRIGHT
(3)
on
the
Stepper side.
(1 Remove the RESISTANCE
SCALE DECALS (102) from
the backing sheet and attach
the Decals to the STEPPER
PEDALS
(5) along side of
the resistance holes so that
the lightest setting
(1) is
aligned
with
the first hole
and
the scale
reads
from
front to back,
Advertisement
Table of Contents
