Table of Contents
Advertisement
PAGE
1%
WEDER
BPORTING
GOODS
STEP 9
AB ARM
ASSEMBLY
FLAT WASHER
C] Assemble a 1" ROUND COVER CAP (9-1 WRITTEN INSIDE)
70 14" FLAT WASHER
(144) onto the Handle Stopper Tube on the AB FRAME (11).
213
1!
3
5
I ev |
| 2 |
ҒАН
55 516" X 2 3/4" HEX HEAD BOLT
D 3 |
ЕГІН
жәр
| 2 |
C] Assemble a 1 1/4" SQUARE PLASTIC INSERT САР (123) into
the long handle end of the AB ARM (12).
73
14" X 34" ROUND HEAD MACHINE SCREW
74 14° Х 21/4" ROUND HEAD MACHINE SCREW
| 1 |
88 3/4" ROUND PLASTIC INSERT CAP
| o2 |
123 11/4" SQUARE PLASTIC INSERT CAP
| 4 |
L] Wipe a small amount of liquid dish detergent along the long
handle of the AB ARM (12) and slide on the 3 3/4" X 10" FOAM
ROLLER (125).
131
1/4" X2 1/4" CARRIAGE BOLT
144
1" ROUND COVER CAP (9-1 WRITTEN INSIDE)
[0 Assemble the AB FRAME (11) to the REAR UPRIGHT (3).
Orient the Ab Frame onto the right side of the Upright over the
short extension of the REAR BASE (2). Using 5/16" X 2 3/4"
HEX HEAD BOLTS (55), bolt through the bracket of the Ab
Frame and then through the Upright.
Assemble 5/16" FLAT
WASHERS
(70). onto the Bolt and secure with 5/16" NYLON
LOCK NUTS (51).
C] Push the AB ARM (12) onto the inside Welded
Tube located directly behind the Handle Stopper
12
Tube
on the AB FRAME (11).
E] Attach
а
SEAT
MOUNTING
BRACKET (14) (This is a flat bracket
2" X 6" with 2 round holes and a
square hole ín the center.) to the top
side of the AB FRAME
(11) at the
hole location
behind
the Welded
14
Tubes.
Bolt
down
through
the
Mounting Bracket and the Ab Frame
with a 1/4" X 2 1/4"
CARRIAGE
BOLT (131). Fasten in place with a
1/4" FLAT WASHER (70) and a 1/4" — HANDLE
NYLON
LOCK NUT (71).
Do not
STOPPER
tighten
at this time. `
те
C] Locate the AB SEAT (12) over
the
SEAT
MOUNTING
BRACKET (14). Assemble up
. through the. Bracket.and
into the
bottom of the Seat with 114" X
- 3/4" ROUND HEAD MACHINE
SCREWS (73).
C] Attach the rear of the SEAT (12)
to the AB
FRAME
(11) by
assembling
а
1/4"
FLAT
WASHER
(70) onto a 1/4" X 2
1/4"
MACHINE
SCREW
(74)
and
bolting
up
through
the
D
Frame and into the Seat.
88
C] Remove the AB STATION DECAL (107) from the backing sheet and attach to the the AB ARM (12).
Advertisement
Table of Contents
