Table of Contents
Advertisement
rauc
зо
WEIDER
SPORTING
GOODS
STEP
B
TOP
FRAME
ASSEMBLY
50
6/16" FLAT WASHER
| qv | (0 Press а2" SQUARE PLASTIC INSERT САР (81) into the front of the
TOP FRAME (15). Press a 2" X 4" PLASTIC INSERT CAP (141)
into the back of the Top Frame.
51 65/16" NYLON
LOCK NUT
55 6/16" X 2 34" HEX HEAD BOLT
СИ
ШЕШЕ
58 swxarwexuepBor
| a |
EE
Lr
ЖЕЛЕ
C] Assemble the ТОР FRAME (15) fo the top of the FRONT UPRIGHT
(10) and the REAR UPRIGHT (3). Align bolt holes end place the
Rear Upright into the Welded Brackets of the Top Frame and the
Guide Rods into the Welded Cross-member Bracket of the Top
Frame.
81
2"SQUARE PLASTIC INSERT CAP
140
596" Х
5"HEXHEAD BOLT
141 2" X 4" PLASTIC INSERT САР
C] Assemble the GUIDE RODS (17) to the Welded Cross-member Bracket of the TOP FRAME (15) by inserting 5/16" X 1/2"
HEX HEAD BOLTS (58) into the open slot at the top and on the inside of the Guide Rod.
Insert the Bolts one through
each side of the Guide Rod and then through the Bracket.
Fasten with а 5/16" NYLON LOCK NUT (51) but tighten only
finger tight at this time. (SEE DETAIL A)
141
50
(
ӘШ 58
51
ІК
>
C] Attach the FRONT UPRIGHT (10)
fo the TOP FRAME (15) by first
assembling
5/16"
FLAT
WASHERS (50) onto two 5/16" X
5 " HEX HEAD BOLT (140)
and then bolting down through the
top of the Top Frame and into the
Welded Bracket of the Upright.
Fasten with 5/16" NYLON LOCK
NUTS (51) but tighten only finger
tight at this time.
(0 Assemble the REAR UPRIGHT (3)
to the TOP FRAME (15) by bolting
with a 5/46" X 2 3/4" HEX HEAD
BOLT
(55) through the Welded
Bracket of the Top Frame an then
through the Upright. Secure with a
5/16" NYLON LOCK NUT (51).
ОРЕН SLOT
DETAIL A
Advertisement
Table of Contents
