Vehicle Installation - Guardian 70ES Operator's Manual

VEHICLE INSTALLATION

1. The ULV sprayer is packaged in a double-walled corrugated box that protects the machine
from damage in shipping and storage. Open the box and remove the sprayer from the top.
You may elect to retain the shipping container for storage purposes.
2. The Guardian 70ES arrives standard with rubber vibration dampening feet on each bottom
corner to provide a stable platform during spray operations. This lightweight machine is
designed to be portable either by hand lifting (suggest two persons) into a support vehicle
such as a side-by-side UTV, golf cart, or maintenance vehicle or by mounting in a more rigid
and semi-permanent fashion to a 2 or 4-wheel drive ATV. In this latter use, remove the
rubber vibration dampening feet and mount the ULV sprayer to the desired machine. The
end user must provide mounting hardware when mounting in a more permanent way.
3. Place the sprayer onto the vehicle or trailer with the engine and blower facing the rear
of the vehicle for ease of reaching the recoil starter pull. Make sure the engine exhaust
has ample area in which to discharge and heat from the exhaust can dissipate without
causing damage to surrounding surfaces, use straps to secure if desired.
Note: AZELIS A&ES is not responsible for mounting and securing the Guardian ULV
sprayers onto a vehicle; it is the responsibility of the owner or end user to do so. AZELIS
A&ES will only make recommendations on how to accomplish the placement and
securing of this unit.
4. Secure Attach the nozzle post assembly to the vertical bracket with hardware supplied
and secure post in place. Attach the air hose from the nozzle assembly to the discharge
port of the air compressor.
5. Loosen the 2 knobs on the Nozzle swivel and adjust
the nozzle vertically to the desired attitude. Loosen
the single bolt below the nozzle swivel and adjust
the nozzle horizontally to the desired position then
retighten.
20
Nozzle Adjustment