Installation; Cold Fog Generator (Ulv Sprayer) Contents; Factory Fluid Levels; Vehicle Installation - Guardian 55 ES Operator's Manual

Table of Contents

INSTALLATION

When you receive your Guardian ULV sprayer, the fluid levels will be as follows:

Engine oil

Compressor

Fuel tank

Formulation tank

Each machine is fully tested functionally and appropriate fluid levels are services beforehand.

1. The ULV sprayer is packaged in a double-walled corrugated box that protects the

machine from damage in shipping and storage. Open the box and remove the sprayer

from the top. You may elect to retain the shipping container for storage purposes.

2. The Guardian 55ES arrives standard with rubber vibration dampening feet on each

bottom corner to provide a stable platform during spray operations. This lightweight

machine is designed to be portable either by hand lifting (suggest two persons) into a

support vehicle such as a side-by-side UTV, golf cart, or maintenance vehicle or by

mounting in a more rigid and semi-permanent fashion to a 2 or 4-wheel drive ATV. In

this latter use, remove the rubber vibration dampening feet and mount the ULV sprayer

to the desired machine. The end user must provide mounting hardware when mounting

in a more permanent way.

3. Place the sprayer onto the vehicle or trailer with the engine and blower facing the rear

of the vehicle for ease of reaching the recoil starter pull. Make sure the engine exhaust

has ample area in which to discharge and heat from the exhaust can dissipate without

causing damage to surrounding surfaces, use straps to secure if desired.

Note: ADAPCO is not responsible for mounting and securing the Guardian ULV sprayers

onto a vehicle; it is the responsibility of the owner or end user to do so. ADAPCO will

only make recommendations on how to accomplish the placement and securing of this

unit.

full

empty

Table of Contents