BMW Z4 ROADSTER Owner's Manual page 120

CONTROLS
For automatic deactivation of front passenger
airbags, refer to page 170.
Seat position and height
After installing a child restraint system, move
the front passenger seat as far back as it will
go and, if possible, bring it up to the highest
position. This seat position and height ensure
the best possible position for the belt and of-
fers optimal protection in the event of an acci-
dent.
If the upper attachment point of the seat belt
is located in front of the belt guide of the child
restraint seat, move the front passenger seat
carefully forward until the best possible belt
guide position is reached.
Backrest width
Adjustable backrest width: before installing a
child restraint system in the front passenger
seat, open the backrest width completely. Do
not change the backrest width again and do
not call up a memory position.
Child seat security
The seat belt on the passenger's side can be
locked to fasten child restraint systems.
120
Transporting children safely
Online Edition for Part no. 01405A88B63 - VI/23
Locking the seat belt
1. Pull out the belt strap completely.
2. Secure the child restraint system with the
seat belt.
3. Allow the belt strap to be pulled in and pull
it tight against the child restraint system.
The seat belt is disabled.
Unlocking the seat belt
1. Unbuckle the seat belt buckle.
2. Remove the child restraint system.
3. Allow the belt strap to be pulled in com-
pletely.
Child restraint systems with
tether strap
General information
When attaching child restraint systems to the
upper attachment points, observe the specifi-
cations and the operating and safety informa-
tion of the child restraint system manufacturer.
Safety information
Warning
If the upper retaining strap is incorrectly used
for the child restraint system, the protective
effect is reduced. There is a risk of injury. En-
sure that the upper retaining strap is guided
to the upper attachment point without twist-
ing and not over sharp edges.
Warning
The mounts for the lower mountings and at-
tachment points of the child restraint system
are intended for attaching child restraint sys-
tems only. If other objects are attached, the
mounts or attachment points can be dam-
aged. There is a risk of injury or risk of dam-
OwnersManuals2.com