Table of Contents
Advertisement
Chapter 3 UEFI Setup Utility
3.1 Introduction
This section explains how to use the UEFI SETUP UTILITY to configure your system. The
UEFI chip on the motherboard stores the UEFI SETUP UTILITY. You may run the UEFI
SETUP UTILITY when you start up the computer. Please press <F2> or <Del> during the
Power-On-Self-Test (POST) to enter the UEFI SETUP UTILITY; otherwise, POST will
continue with its test routines.
If you wish to enter the UEFI SETUP UTILITY after POST, restart the system by pressing
<Ctrl> + <Alt> + <Delete>, or by pressing the reset button on the system chassis. You may
also restart by turning the system off and then back on.
Because the UEFI software is constantly being updated, the following UEFI setup screens
and descriptions are for reference purpose only, and they may not exactly match what you
see on your screen.
3.1.1 UEFI Menu Bar
The top of the screen has a menu bar with the following selections:
Item
Main
Advanced
Server Mgmt
Security
Boot
Event Logs
Exit
Use <
> key or <
then press <Enter> to get into the sub screen.
48
Description
To set up the system time/date information
To set up the advanced UEFI features
To manage the server
To set up the security features
To set up the default system device to locate and load the
Operating System
For event log configuration
To exit the current screen or the UEFI SETUP UTILITY
> key to choose among the selections on the menu bar, and
Advertisement
Table of Contents
