Alpine CDA-7832R Service Manual page 13

| CDA-7832R
47 ~—~ | No connection terminal.
[#/ 3/8] 2
&
48 NC — | No connection terminal.
49 | DTS STRT
ie) )_| Communication sync. signal output terminal to DTS p-COM.
50 ALARM
O | TP-OFF ALARM signal output terminal.
51
© | CE signal output terminal to DTS -COM.
POWER ON
PWR IC ON
NC
Ai-DIN IN/OUT
59 IN-INT
60 RESET
61 | REMOCON
B-HOLD Battery (4.3V) detection signal input terminal.
A-HOLD ACC detection signal input terminal.
BUS-IN Ai-NET BUS Data input terminal.
SW-A Disc insertion deteciton signal input terminal (1).
BUS-OUT Ai-NET BUS Data output terminal.
67 SW-B
Audio and Key Lighting power control signal output terminal.
Power IC stand-by control signal output terminal.
°
|
FRE
No connection terminal.
Set up detection terminal for input/output of Ai-NET DIN. (H : OUTPUT)
In Interrupt signal input terminal. (H : Active)
System Reset signal input terminal.
Remocon Data signal input terminal.
2/8] 8|
8
Disc insertion detection signal input terminal (2).
Power supply terminal.
System Clock OSC output terminal. (4.19MHz)
System Clock OSC input terminal. (4.19MHz)
8
<
'
70 x1
71 GND | — | GND connection terminal.
72 NC | — | No connection terminal.
GND — |GND connection terminal.
74 AVop
—- | Analog power supply terminal to A/D converter.
Reference voltage input terminal to A/D converter.
a
or
j
<
e]
m ba
76 GND — | GND connection terminal.
GND connection terminal.
78 GND — | GND connection terminal.
79 T-SENS
80 NOSE ON
'emperature sensor signal input terminal.
7
ront Panel detection signal input terminal.
139s