Honda AFP125CRF 2018 Owner's Manual page 86

Tyre Puncture
u
9. Remove the rear axle shaft, drive chain
adjusters, side collars and rear wheel from
the swingarm.
Rear axle
shaft
Installation
1. To install the rear wheel, reverse the
removal procedure.
2. Tighten the brake stopper arm nut.
Torque: 22 N·m (2.2 kgf·m, 16 lbf·ft)
82
Removing Wheels
Drive chain lock nut
Drive chain
Drive chain
adjusting nut
3. Adjust the drive chain slack.
4. Adjust the rear brake pedal freeplay.
P. 60
2
5. Tighten the rear axle nut.
Torque: 59 N·m (6.0 kgf·m, 44 lbf·ft)
6. After installing the wheel, apply the brake
pedal several times, then check if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not rotate
freely.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
A used cotter pin may not effectively secure a
fastener. Always replace a used cotter pin with
a new one.
P. 66
2