Table of Contents
Advertisement
Option #
1
2
3
4
5
6
7
8
ACTIVE ARMING
To arm the system, press the #1 button on the transmitter. You will hear a single
siren chirp and the lights will flash once. Doors will lock and the starter wi ll be
disabled if these optional features are installed. The red LED in the vehicle will
start flashing after 15 seconds. After a short delay to allow vehicle and electronics
to stabilize the system will be completely armed. If there is an intrusion into the
vehicle or hard impact to the body the alarm will sound and flash the lights for 45
seconds. After 45 seconds the system will automatically shut off and re-arm to
continue to protect the vehicle. If a door is left open the unit will cycle a second
time and continue to protect the other non-tampered zones.
Arm/Disarm with a Soft (NIGHT) chirp press and release the #2 (Small)
button quickly.
DISARMING
To disarm the alarm and unlock the doors, press the #1 button on the transmitter. You will hear 2 siren chirps and the
lights will flash twice. Dash LED stops flashing.
REMOTE PANIC PROTECTION
To sound the alarm upon command, press and hold the #1 Button for at least (2) seconds until the siren sounds.
Press the same button again to reset panic mode.
TRUNK/HATCH POP (REMOTE AUX. OUTPUT 1, OPTIONAL)
To pop the trunk (if optional feature is installed), press the #2 Button for at least 1 second.
OPTION CHART
Option Description
Passive Arming
Autolock with Ignition
Double Unlock Pulse
Dome Light Timer
Door lock pulse
Carjack
Lock when Passive Arming
Restore Options to default
OPERATION
* = DEFAULT
Selection
Button 1
ON or OFF
OFF*
ON or OFF
ON*
1 or 2 pulses
1 Pulse*
10 or 60 sec.
10 sec.*
1 or 3 sec.
1 sec.*
Active or Passive
Active*
ON or OFF
OFF*
Button 1
Press Btn. #1
Note:
To
Button 2
ON
OFF
2 Pulses
60 sec.
3 sec.
Passive
ON
BUTTON #1
BUTTON #2
Advertisement
Table of Contents
