Table of Contents
Advertisement
Set Up Features
(cont.)
Auto Progrsm
- The Auto Programming feature
allows you to place all channels with a video signal into
Channel Scan Memory. When you press the CHANNEL
UP or DOWN button, only those channels with a video
signal will be accessed.
Note:
TV or Cable Tuning mode must be set properly,
for your system.
1.
Press the ACTION button to display the Main Menu.
2.
Press the CH UP/DOWN and VOL LEFT/RIGHT
button to highlight the Set Up Icon.
3.
Press the ACTION button to display the Set Up
Menu.
4.
Press the CH UP/DOWN button to highlight AUTO
PROGRAM.
5.
Press the VOL LEFT/RIGHT button to start Auto
Programming Scan. Channels will automatically
advance until all channels have been scanned.
• Channel numbers with video signal present will
turn blue which indicates stored in Channel Scan
Memory.
6.
Press the ACTION button twice to exit the Set Up
Menu.
..
Note: Some channels with very weak signals may
be locked into memory. If desired, these
channels can be deleted manually using the
Manual Program feature!
Helpful Hints:
After Auto Programming:
Blue channel number indicates channel is in Channel
Scan Memory.
All channels are available by direct access using the
numeric keypad (0 through 9 buttons).
Up to 15 channels will be programmed into the
FAVORITE Channel Scan after Auto Programming
Scan has been completed. Any original channels that
were programmed into FAV CHANNEL will remain.
(Refer to Favorite Channel Scan for deleting unwanted
channels.)
Manual Program
- This feature allows you to
select which channels are placed into Channel Scan
Memory, so when you press the CHANNEL UP/DOWN
button, only those channels you desire will be accessed.
1.
Press the ACTION button to display the Main Menu.
2.
Press the CH UP/DOWN and VOL LEFT/RIGHT
buttons to highlight the Set Up Icon.
3.
Press the ACTION button to display the Set Up
Menu.
4.
Press the CH UP/DOWN button to highlight MANUAL
PROGRAM.
5.
Press the VOL LEFT/RIGHT button to display
Manual Program Menu.
6.
Use the Remote Control Numeric Keypad (0
through 9 buttons) or CH UP/DOWN buttons to
select channels.
7.
Press the VOL RIGHT button to add channel(s) to
memory (blue). Press the VOL LEFT button to
delete channel(s) from memory (yellow).
8.
Repeat Steps 6 and 7 to continue adding or deleting
channels.
9.
Press the ACTION button twice to exit the Set Up
Menu.
-
40
-
Advertisement
Table of Contents
