Table of Contents
Advertisement
Recall Button
- Press the RECALL button to
review
® Audio Mode status
© CH number or Video Input selected
(0 Sleep Timer status
(J) Clock time
@ Channel Caption (Station IdentiNer)
StarSighI Activated
StarSight Not Activated
R-Tune Button
- Pressing the R-TUNE (RAPID
TUNE) button will switch between the last two channels
selected on the numeric keypad
NOTE: When rapidly scanning channels with the
CHANNEL UP/DOWN button, pressing the
R-TUNE button will switch between the last
channel scanned, and initial channel al the start
of scanning
CHANNEL NDW
BEING VIEWED
Press Button
Ptbss Button Again
CHANNEL
PREVIOUSLY VIEWED
Multi Button
The MULTI button can be programmed to operate up
lo 6 Remote function buttons at the same time
For ENample:
TV Power/On, VCR Power/On, and
Cable box Power/On (selected brands) can be operated
at the same time with one press of the MULTI button
Procedure
1
Program the Remote for the selected device
Infrared access code Confirm that the Remote
Control IS compatible with the device
2
Face the Remote Control transmitter away from all
equipment remote sensors
3
Press and hold Ihe Remote POWER button, then
press and hold Ihe ACTION button down at the
same
lime
for three
seconds
(All
previous
commands are erased)
PRESS AT THE SAME TIME FOR
three SECDNDS
4
After three seconds, all the illuminated buttons will
begin to flash Release the POWER and ACTION
buttons
5
Press the MULTI button (Waiting more than 30
seconds without pressing another button will exit the
programming mode)
6
Press a maximum of six (6) function buttons on Ihe
Remote Control
Each button you press is equal to one function If six
(6) Remote button functions are entered, all will
register in the MULTI button memory in the
sequence entered When finished, press the MULTI
button to exit the programming mode
The following is an example flow chart of Remote
functions that can be programmed into the MULTI
button. (The VCR Mode button should be pro¬
grammed before starting procedure see pg 42).
You can now turn the TV and VCR ON/OFF at the
same lime with one press of the MULTI button
To delete entered functions
- Press and hold the
Remote POWER button, then press and hold the
ACTION button down at the same lime for three
seconds You can now enter from one to six different
R^^e function^_
' Note:
i You can also program the MULTI button to perform
, most individual Remote Control button functions
, Buttons which continuously perform a function as
; long as pressed (Volume Up/Down, Channel
I Up/Down, etc ] cannot be programmed, only those
' buttons which perform a function when initially
I pressed (Power On/Off, Mute, Direct Channel Entry,
etc ) can be programmed_ _ _
-
19
-
Advertisement
Table of Contents
