Ariens EZRider 915 Series Owner's/Operator's Manual page 20

1. Mower Belt 5. Sheave Covers
2. Drive Pulley 6. Mower Idler Spring
3. Idler 7. Main Idler Spring
4, Mower Drive Belt 8. Electric Clutch
Figure 7
Clutch Shaft Belt Replacement 1. Clutch Shaft Idler 5. Idler Springs
1. Remove transaxle belt (Figure 8). 2. Clutch Shaft Belt 6. Mower Drive Belt
: . 3. Transaxle idler 7. Mower Drive Idler
2. Remove clutch shaft idler spring from frame. 4. Transaxle Belt 8. Main Idler Spring
3. Remove belt from engine sheave.
Figure 8
4. Remove belt from clutch sheave.
5. Install new belt in reverse order, checking for belt
alignment and clearance.
5. Connect clutch idler spring to frame.
6. Reinstall transaxle belt.
LUBRICATION
Apply a small amount of oil to the pivot points as
required for smooth and proper operation.
Grease the fittings on the front wheel spindles, the idler
arms, and the steering controls every 50 hours of
operation (Figures 8 and 9).
Apply &'Sten Mix Hi-Temp Grease or equivalent to the
lube fittings. Order P/N: 00036800 - Three pack of 3
oz. cartridges or 00036700 - Ten pack of 14 oz.
cartridges.
0E0031
0E0192
Figure 9
Ariense EZRider™ Orig. 1/98