Aiwa XR-M191 Operating Instructions Manual page 13

When recording on tape, close the disc compartment before
starting to record.
Volume or tone adjustment does not affect recording.
e "CAN'T REC' is displayed if you attempt to record a tape
with the tab broken off.
To stop recording
Press Ml.
To pause recording (only for TUNER or AUX/VIDEO
source)
Press Il. Press again to resume.
To record a selected set of tracks from a CD
Program the desired tracks (see "Programmed playback") and
then press @REC/REC MUTE.
To record a 4-second blank space (only for TUNER
or AUX/VIDEO source)
1 Press @REC/REC MUTE during recording or in recording
pause mode.
"Tq" flashes on the display for 4 seconds (a blank space
is made in the meantime) and then the unit enters recording
pause mode.
To record less than a 4-second blank space, press @REC/
REC MUTE again while "Gixed" flashes.
To record more than a4-second blank space, press @ REC/
REC MUTE again after the unit enters recording pause mode.
Each time the button is pressed, a 4 second blank space is
added.
2 Press Hl to resume recording.
To erase a tape
1 Insert the tape to be erased into the deck. Set the tape to the
desired point if needed.
2 Set the reverse mode by pressing TAPE/REV MODE.
3 Press AUX/VIDEO and turn the connected equipment off.
4 Press @REC/REC MUTE.
Edited CD recording
Al Edit Recordin
When recording a whole CD, Al Edit Recording takes the length
of your tape into account and rearranges the recording order of
the tracks if necessary, so that no track is cut short at the end
of the side. Prepare a tape long enough to record the CD.
1 Insert the tape into deck.
2 Press CD to select the CD function and load the
disc.
3 Press MODE repeatedly on the remote control
until "Al EDIT" appears on the display.
The "Al" and "EDIT" indicator flashes and lights up
respectively. "Al C-OO" appears on the display.
4 Press the numbered buttons on the remote
control to enter the length of the recording tape.
10 to 99 minutes can be specified.
- For a 60-minute tape press 6 and 0.
In a few seconds, the unit determines the tracks to be
recorded for each side.
The recording time left for side A appears on the display.
© <<, > can also be used to specify tape length.
5 Press @REC/REC MUTE to start recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and
recording starts. When recording on the front (side A)
ends, recording on the back (side B) starts.
To stop recording
Press Ml. Recording and CD play stop simultaneously.
To clear the edit program
Press MCLEAR twice so that "EDIT" disappears on the
display.
To check the order of the programmed track numbers
Before recording, press MODE on the remote control to select
side A or B, and press << or > repeatedly.
Aj Edit Recording cannot be used with discs with more than
30 tracks. "TR OVER' is displayed.
Recording cannot start from a point halfway in the tape.
13
En