Technics SC-CH700 Operating Instructions Manual page 55

5 Select the desired source.
0 Press one of the timer select buttons to select tuner
source.
Each time you press one of the timer select buttons, "CD",
"TAPE" and "TUNER" is alternately displayed.
SAT VOLUME
ONCE 0PLAY \[5q^ yCR / L MAX
ON STANDBY \ ^ ' /
(g) Press the timer set button.
(D Press one of the timer select buttons to select channel
"3".
(Only when the tuner source is selected)
ONCE
ON STANDBY
Qplay \[bov> yen /
VOLUME
MAX
^ 7 ^ T
® Press the timer set button.
6 Select the type of timer operation "PLAY" or
"REC".
(Only when the tuner source is selected)
® Press one of the timer select buttons to select
"PLAY".
Each time you press one of the timer select buttons,
"PLAY" and "REC" is alternately displayed.
(D Press the timer set button.
7 Set the OFF time.
0 Press one of the timer select buttons to select "7".
SAT
VOLUME
ONCE niPLAY lBav>VCR L MAX
OFF ^TANDBY
\ ... /.. : : ; = • —
—
; ■ —: :
: • .•••••. .
B S Nm
_
' \'.
BALANCE
(D Press the timer set button.
® Press one of the timer select buttons to select "IS".
® Press the timer set button.
BAT
ONCE
0PLAY /
OFF STANDBY \ ^ '
■7-^-T
8 Adjust the volume level for timer play.
0 Adjust the volume level using the volume level con¬
trol.
(D Press the timer set button.
The volume level memorized will activate at timer play, even if
the volume setting is changed after the above prorodures
have been followed.
•When setting the timer recording, skip this step.
9 Switch the power to standby mode.
To confirm the timer setting
Press the timer setting confirmation button.
1 1
RECALL
Each time you press the timer setting confirmation button, the
display will change as follows:
0 "ONCE" power-ON time
ONCE
ON STANDBY
[SBEC
@ "ONCE" power-OFF time
ONCE
OFF STANDBY
»*r Huge
r 3
1
@
"WEEKLY" power-ON time
MDNTUEVYEDTNUnB
WEEKLY
ON STANDBY
Qplay
®
"WEEKLY" (jower-OFF time
MONTUEWEOIHUFM
WEEKLY
OFF STANDBY
li57>vcB ^
® Present time
■ To change the timer setting
1) Press the power "STANDBYc!)/ON" switch to switch on the
power.
2) After selecting "ONCE" or "WEEKLY" press the timer set
button to proceed to the step you want to change.
3) Press one of the timer select buttons to change the setting.
4) Press the timer set button to proceed to step 8.
5) Switch the power to standby mode.
Note:
•You can confirm the timer setting in the power standby condition.
55