Table of Contents
Advertisement
3.
Let dry for at least 3 days.
Check for liquid inside the
phone before replacing
compartment covers &
reconnecting cords.
Resetting Handsets
If you have trouble with a handset
or if you want to replace one,
clear the registration information
from the base and the handset:
1.
Press & hold
same time until you see the
System Reset
2.
If you still have the base
the handset is registered to,
select
Deregister
select the handset you want
to reset. If you don't have that
base anymore, select
Unavailable.
To confirm, select Yes. The
3.
handset displays
registered.
Registering Handsets
If you see a "not registered"
message on a handset, you must
register it to a base before using
it.
1.
Place the handset in the base;
the display should say
Registering.
2.
Wait until the display says
Registration Complete
- English
# at the
and
End
menu.
HS, then
Base
Handset not
Handset
(about
30 seconds), then pick up the
handset; press
If you don't hear a dial
tone or the display says
Failed, charge the
Registration
battery completely, then
try again.
Adapter and Battery
Information
AC adapter
Part number
Input voltage
Output voltage
Use only the supplied AC adapters.
Use the proper adapter for the base &
any chargers.
Do not place the unit in direct sunlight
or subject it to high temperatures.
Battery pack (with normal use)
Part number
Capacity
Talk time
Standby time
Battery life
Replace the battery when the talk or
standby time becomes noticeably re-
duced. For replacements, call the Parts
Department (see the front cover).
When the battery gets low, the handset
beeps and shows a low battery alert;
put the handset in the cradle for
recharging.
Rechargeable Battery Warning
This equipment contains a recharge-
able Nickel-Metal-Hydride (Ni-MH)
battery.
Nickel is a chemical known to the state
of California to cause cancer.
Do not short-circuit the battery.
.
Talk
PS-0035
120V AC, 60 Hz
8V AC @ 300mA
BT-1022
300mAh, 2.4V DC
about 7 hours
about 7 days
about 1 year
Advertisement
Table of Contents
