Table of Contents
Advertisement
Resetting Handsets
If you want to register the handset to a different base or replace a handset with another one, you must first clear the
registration information from the base and the handset.
1. Press and hold
[
]
and
[#/>]
for at least 5 seconds, until the SYSTEM
RESET menu appears.
2. Move the cursor to select the handset ID to be de-registered from the list,
and then press
[select/
]
. DEREGISTER HS appears.
3. The phone asks you to confirm the deregistration. Move the cursor to select YES, then press
A confirmation tone sounds. The handset clears the registration information from the base and then deletes its
own link to the base. The handset now displays MODELS VARY! CHARGE HANDSET ON THE BASE FOR
REGISTRATION OR REFER TO OWNER'S MANUAL. To register the handset to a base see page 24.
Setting up the Phonebook
Your phone lets you store up to 100 names and numbers in your phonebook in
the handset. Your phone shares memory between your phonebook and CID
entries. Once you store 100 phonebook entries, CID information is not stored and
only appears during a new incoming call. When phonebook and CID entries are
full, a beep sounds and MEMORY FULL appears. You cannot store any
additional names and numbers unless you delete some of the existing ones.
You can also use the phonebook to store a group of numbers (up to 20 digits)
that you may need to enter once your call connects. This is referred to
as chain dialing.
Creating Phonebook Entries
To store names and numbers in your phonebook, follow these steps:
1. When the phone is in standby mode, press
2. To create a new phonebook entry, move the cursor to select STORE NEW.
3. Press
[select/
]
. STORE/EDIT NAME appears.
4. Enter the name for this entry(STORE/EDIT NAME).
[
]
.
[25]
[select/
]
.
Advertisement
Table of Contents
