Connecting The Power - Uniden BCT7 Operating Manual

Connecting the Power

The BCT7 is designed to be used in any vehicle which has a 12-volt DC negative ground electrical system. If you cannot
determine the polarity of your vehicle, consult your vehicle dealer for information.
1. Connect the BCT7 power cord
directly to the fuse block or battery
of your car.
- OR -
Plug one end of the cigarette lighter
power cord into your vehicle's
cigarette lighter.
2. Connect the power cord to the
jack marked "DC 13.8V" on the
back of the radio.
3. Attach the external antenna
connector to the jack marked
"ANT."
Note: The power cord provided with your BCT7 contains a 1-amp fuse. Whenever necessary, replace it only with
the same type of fuse.
Uniden recommends using an external antenna designed specifically for scanning radios.
Do not use the telescoping antenna in a mobile installation.
26