Setting Up The Scanner; Connecting Power - Uniden UBC360CLT Owner's Manual

Radio scanner

Hide thumbs

Table Of Contents

Table of Contents

These guidelines will help you install and use your new scanner:

• If your scanner receives interference or electrical noise, move the

scanner or its antenna away from the source. You might also try

changing the height or angle of the antennas.

• Use an optional mono earphone or mono headset with proper

impedance for private listening.

• Do not use the scanner in high-moisture environments such as in the

kitchen or bathroom.

• Avoid placing the scanner in direct sunlight or near heating elements

or vents.

Connecting Power

• Insert the supplied AC Adapter's

barrel plug into the power jack

on the back of the scanner. Then

plug the Adapter into a standard

household outlet that supplies

30V AC, 50Hz. Do not plug the

adapter into a switch controlled

outlet.

• Open the battery compartment

and insert 3 AA batteries.

Be sure to note the polarity

markings in the battery

compartment. You can use

either alkaline or rechargeable

batteries, but the scanner will

not recharge batteries in the

compartment.

• Use only fresh alkaline AA

batteries. Rechargeable

batteries can be used, but

battery life is shorter than with

alkaline batteries.

• Always remove old or weak

batteries. Batteries can leak

chemicals that destroy electronic circuits.

• Do not mix old and new batteries, different types of batteries

(standard, alkaline, or rechargeable) or rechargeable batteries of

different capacities.

UB355ZH(UBC360CLT).indd