Hold Function; Operation; Sequential Play Basic Play - Panasonic SL-CT590 Operating Instructions Manual

Portable cd player
Hide thumbs Also See for SL-CT590:
Table of Contents

Advertisement

HOLD function

O P E
N
VO LUM
HOLD
HOLD
HOLD mode
Sequential Play
1
OPEN
Label must face
upward.
near the center
so the disc clicks
firmly into place.
LU
ME
VO
OPEN
Close the lid.
ME
LU
VO
OPEN
Follow steps 1–5.
In step 2:Connect the stereo headphones/stereo earphones to the headphone jack [
In step 5:The volume range is 0-25. Press and hold to change the volume successively. The volume changes
when pressed while the level is displayed. If any other display is shown, it changes to show the cur-
rent level. The volume returns to 10 when you disconnect the power source.
≥Play stops automatically when all the tracks have been played.
≥If the unit has been connected to the car audio system, set this unit's volume level to 10, then adjust the vol-
ume level on the system.

Operation

Press during play.
To pause play
Press during play.
To stop play
Resume function
Stop mode
Play starts from the beginning of
the current track the next time you
press [1/;].
Press during stop mode.
To turn off the
Off mode
unit
Press during play.
(Press [:] twice to skip to the
Skipping
beginning of the previous track.)
tracks
Backward
Searching
through tracks
Press and hold during play.
Resume function notes
≥Opening the lid while in the stop mode or replacing the disc while in the off mode cancels the function. (It may
remain active if you replace a disc in the off mode.)
≥Play may resume from the beginning of the next track if you stopped play near the end of a track.
≥The resume function works automatically and cannot be turned off.
3
This function causes the unit to ignore short, accidental
button presses. (The disc lid can still be opened and
closed.)
The HOLD function prevents the following:
≥The unit is powered on accidentally when not in use,
RY
ME MO
E
causing the batteries to run down.
≥A button is accidentally pressed during play, interrupt-
ing the operation.
To use the HOLD function
Set [HOLD] to the HOLD position.
Release
Basic Play
Press
O P E N
2
R
L
Button
Total number of tracks Total playing time
≥During program play (page 4), these but-
tons are used to skip forward or backward
through the programmed sequence of
tracks.
Forward
≥You cannot skip to tracks that have been
played in random or random repeat play
(page 4).
≥During program play, 1-track repeat play,
random play and random repeat play (page
4), search operation is limited to the cur-
rent track only.
Plug type:
3.5 mm (1/8 in.) stereo
Decrease
. (Plug in firmly.)
Ë]
Display/reference
S-XBS
Press again to restart play.
S-XBS
No indicator is shown
(
"
" indication
When the unit is in HOLD mode, pressing any button
causes the indication "(" to appear on the display.
When the unit is powered off
The "(" indication appears only when [1/;] is
pressed.
Before operating the buttons
Be sure to move [HOLD] to release the unit from
the hold mode.
3
HOLD
4
Track number in play
VOL
Elapsed playing time of each track
5
VOLUME
VOL
Increase
For your reference:
)
"
" indication
This indication appears for about 30 seconds if [
pressed when no disc is loaded in the unit or if the disc is not
properly secured.
*
"
" indication
This indication appears for about 10 minutes when the lid is
opened. (However, the indication does not appear when the
unit is powered off.)
Auto-off function
If you leave the unit in stop mode for about 10 minutes (30 sec-
onds if disc is not loaded), it turns off to save the batteries.
Removing discs
1
Press [∫] to stop play and disc rotation.
2
Slide [OPEN] to open the lid.
3
Once the disc has stopped, lift the disc out with
your finger in the depression.
Do not stop the disc by hand or try to remove it before it stops
rotating. This can damage CDs.
Depression
OPEN
Note!
Never insert foreign objects into the unit.
Note on CD-R and CD-RW
This unit can play CD-DA format audio CD-R and CD-RW
that have been finalized
§
upon completion of recording. It
may not be able to play some CD-R or CD-RW due to the
condition of the recording.
§
Finalizing is a process that enables CD-R / CD-RW play-
ers to play audio CD-R and CD-RW.
RANDOM
S OFF 1
M
.
S-XBSTRAINLIVE
S-XBS
/
] is
1
;
M E
LU
VO

Advertisement

Table of Contents
loading

Table of Contents