Setting A Different Telephone Number For B2-Channel For Maintenance; Diagnosing The Hardware - Sony RSE-500 Operating Instructions Manual

To cancel diagnostics
Set LOOP BACK and DEBUG to OFF. Move the
cursor to <EXIT> and press ENTER. Diagnostics are
canceled and the main menu appears.
Setting a Different Telephone
Number for B2-channel for
Maintenance
1 Select 29. MAINTENANCE from the SETTING
menu.
Press ¥ three times.
Set 2ND TELEPHONE# to ON using € or ®, then
press ENTER.
Ja O N
Select the second telephone number of the remote
site using € or ®, then press ENTER one by one.
The second telephone number is entered in the
second telephone number box.
* An asterisk 1s displayed where nothing is entered.
5 After entering the second telephone number, move
the cursor to «OK» using ¥, then press ENTER.
6 Select the second subaddress of the remote site
using € or >, then press ENTER one by one.
The second subaddress is entered in the second
subaddress box.
* An asterisk is displayed where nothing is entered.
7 After entering the subaddress, move the cursor to
«OK» using ¥, then press ENTER.
The setting is registered and the SETTING menu
appears.
_ Diagnosing the Hardware
After executing diagnostics, all settings are reset to the
same state as when the power 1s turned on except for
the items in the SETTING menu.
Audio and video signals diagnostics
* For a video signal loop back, you need a camera and
a monitor.
* For an audio signal loop back, you need a headset.
1 Select 31. DIAG from the SETTING menu.
The following screen appears.
DIAG
ARE YOU SURE?
After execution
it will Reboot.
<CANCEL> «OK?
2 Select «OK» using +, then press ENTER.
The following screen appears.
DIAG
VIDEOS AUDIO
RS-232C
<EXIT>
3 Select VIDEO & AUDIO, then press ENTER.
The following screen appears.
UIDEO&QUDIO
[CAMERA SELECT:
ANALOG LOOP BACK
DIGITAL LOOP BACK
LOCAL LOOP BACK
REMOTE LOOP BACK
DISPLAY MODE
| AUDIO
<EXIT>
4 Select an item to diagnose using + or y, then press
ENTER.
The hardware self-diagnostic starts.
After executing the LOCAL LOOP BACK diagnostic,
the DIGITAL LOOP BACK diagnostic cannot be
executed.
|
MANI
z Ja1deyo
10,444,
111