Checking The Calling Party Or Called Party; Setting The Loop Back And Debugging - Sony RSE-500 Operating Instructions Manual

zo lll
Permission to Be Connected
aa o SEN RN NND GRE
Checking the Calling Party or
Called Party Number
You can check a call against the numbers registered on
the LIST (RECEIVE) menu. If you set RECEIVE
CHECK to ON, the unit cannot receive any calls other
than from the registered numbers.
If you set LDN CHECK to ON, the unit checks a
called party number against your local directory
number.
1 Select 30. RECEIVE CHECK from the SETTING
menu.
The following menu appears.
RECEIVE CHECK
RECEIVE CHECK ON (OFF
LON CHECK ON OFF
«CANCEL» «OK»
2 Select receive check ON or OFF using € or 9.
then press ¥.
3 Select LDN check ON or OFF using € or >., then
press Y.
4 press ENTER.
The setting 1s registered and the main menu
appears.
If you cannot receive a call, set LDN CHECK to OFF.
You can diagnose the Video Transmitter system. The
diagnostics are executed by looping back the audio/
video signals and serial data.
Setting the Loop Back and
Debugging i
1 Select 29. MAINTENANCE from the SETTING
menu.
The following screen appears.
MAINTENANCE
OFF LOOP BACK
OFF DEBUG
OFF HEALTH CHECK
OFF 2ND TELEPHONE?
2ND TELEPHONES:
[KKK KKK KKK KK KKK KKK KKK KK)
SUB ADDRESS: [kkkKKKKKKK]
0123456789 85
<CANCEL>
2 Select loop back ON or OFF using € or », then
press y.
3 Select debugging ON or OFF using € or >, then
press * three times.
4 Press ENTER.
The setting is registered.
When LOOP BACK is set to ON
The analog video input signal from the camera is
digitized and encoded when you call through the DIAL
LIST menu. This signal 1s looped back and decoded
before sending it via ISDN. This decoded signal is
displayed on the monitor after converting to an analog
signal.
When DEBUG is set to ON
The ISDN line connection status is output to the USER
DATA port.
When HEALTH CHECK is set to ON
When the devices at remote site do not shut down
properly, such as disconnect the line before turning off
the devices, or error occurred in ISDN lines,
disconnect the line properly.
The health check does not function when the local
Video Transmitter turns off the power before
disconnecting the line.