Setting The Password; Setting The Date And Time - Sony RSE-500 Operating Instructions Manual

pore errr
zane lil
Registering the Local Site Information
* When you connect via the V.35 interface, the
terminal adaptor is required.
* When you connect via the V.35 interface, you need to
set the line rates of the calling party and called party
to the same rate.
* Turn on the terminal adaptor after turning on the
Video Transmitter.
Setting the Password
You can set a password for security purposes. (1f you
do not set a password, you can connect to video-
conference.)
When a remote party which does not know the
password tries to connect to the local site, the line may
be connected temporarily and the local picture and
audio may be sent to the remote party. If vou reject the
communications other than specific parties, use the
LIST (RECEIVE) menu and register the parties to
permit the communications.
T Select 4. PASSWORD from the SETTING menu.
The following screen appears.
PASSWORD: ON (OFF
KKK (XKKKKKKKKK *]
0123456789
ABCDEFGHI JKLMNOP
QRSTUUUXYZ
abcdefshiJjklmnoe
arstuvuxyz
I"BH$76' Oxt.-.::|
€2»?Q[N^ .1GO-x/NO
SP BS
<CANCEL> «OK»
2. Select ON or OFF using # or * to determine
whether to set a password or not, then press ¥.
ON: Sets the password.
OFF: Does not set the password, but you can still
register a password.
3 Select characters for the password using €, 4. * or
Y, then press ENTER character by character.
The selected characters are entered in the password
box.
* The password can be up to 15 characters long.
e Select SP for a space.
* An asterisk is displayed where nothing is entered.
4 After entering the password, move the cursor to
«OK» using ¥, then press ENTER.
The password is registered and the SETTING
menu appears.
Setting the Date and Time
Í Select 19. CALENDAR from the SETTING menu.
The following screen appears.
r
CALENDAR
YY.MM.DD HH:MM:SS
(88.07.04 01:50:571
0123456789 + =
<CANCEL> <OK>
2 If you set all the date and time, go to Step 3.
To select the item of date or time you want to set,
select € or ® using the € or » key and press
ENTER repeatedly to move the cursor.
The cursor moves among the date (YY.MM.DD)
and time (HH:MM:SS) cyclically.
[w [ww [on [ws [ww [55 —
3 Select a number using € or », then press ENTER.
The selected number is entered in the box and the
cursor moves to the right.
4 Repeat Steps 2 and 3 to enter the date and time.
5 After entering the date and time, move the cursor
to <OK> using Y, then press ENTER.
The date and time are set and the SETTING menu
appears.