Airlink101 Host RJ-11 User Manual page 30

Configuration Settings and Commands
FIGURE 12. Host RJ-11 IP Gateway: Time Settings
Current System Time
The cuirenl syslem time is:Wed. 22 Nov200617:25:52 urc.
ITtnis lime is riol correct please verit* ihattne (me settings below are correct and Ihst at leasl one orthe configured
Network Time Protocol (NTP) Settings
• NTP Servers
• NTP Servers from DHCP
1 Save NTP Settings [
HTTP Time Settings
When the device server bools, it will attempt to set the time iromanyweb servers listed here, and set the system
lime accordingly.
• HTTP Servers
I Save HTTP Time Sellings ]
If the device server is configured to use DHCP, it will try to get NTP server information from the
DHCP server. You may also manually set up the addresses on this page. The NTP service uses
UDP port 123. If your device server is behind a firewall you may need to allow accesses to this port
through the firewall. Adding or changing the NTP server will trigger the Host RJ-11 IP Gateway to
The HTTP server you specify need not be a designated time server - just a reliable server. The
device server derives the system time from the HTTP header the server returns. Adding an HTTP
server will not automatically trigger getting the time. You must reboot for this to take effect.
Security Settings
The security settings page includes settings for • the System Passv