Pioneer XR-P270C Operating Instructions Manual page 50

TROUBLESHOOTING
If the trouble cannot be rectified even after exercising the chec
your dealer to carry out repair work.
_—.
Symptom
Cause
Remedy
There is no power.
eAC cord is unplugged.
ePlug the power cord into a wall socket.
No sound from speakers.
@ Volume is turned all the way down.
e Raise volume setting.
@ Strip vinyl! insulation from speaker wire tip
| interference.
Sound is distorted, or no stereo
sound (during FM broadcast).
im
e Antenna is in poor position.
e Broadcast is weak.
e The MONO button is on.
e Use an external antenna (page 10).
ePress the MONO button (on the remote
control unit (page 14)).
CD Player
Cassette Tape Deck
;
When playback is started, it stops
immediately.
Pauses or stops during playback.
e Disc is loaded upside down.
e Dirt, etc. on the disc.
No sound.
With certain discs, loud noise is
produced, or play stops.
Cassette door does not open.
Cassette door does not close.
Tape does not move.
e Player is in pause mode.
@ Disc has a bad scratch or warp.
e Deck has not stopped.
e@Power was switched off while a tape was
running.
e Cassette is inserted incorrectly.
e Load the disc correctly with the label side UP.
e Clean the disc.
ePress the Pause/Play (1t/>) button (on the
remote control unit).
e Replace the disc.
ePress the STOP (m) button.
e Switch on the power again.
e Reload the cassette tape correctly.
Cannot record or copy tape.
Erasure prevention tabs are broken off.
e Dirty head.
eApply adhesive tape over the tab holes.
eClean head (page 48).
Previously recorded sounds
remained.
e Dirty head.
e Clean head (page 48).
High-range sounds are over-
emphasize.
e The cassette tape used is a TYPE U (HIGH/CrO2)
or TYPE IV (Metal) tape.
—
|
@ Use only TYPE I (Normal) tapes.
Remote Control Unit
& Others
Remote control unit does not
work.
e Batteries are dead or no batteries in the remote
control unit.
ePoor angle or too great a distance from the
remote contro! sensor window.
eA fluorescent light is shining on the remote
sensor window.
elnsert new batteries.
e Use within 7 meters and within a 30 degree
angle of the remote sensor window (page 6).
Turn off the light.
Timer does not work.
e Current time is not set.
e@ The TIMER button is set to the off position.
e Set current time.
eSet to the on position (page 44).
the power off and then on again or unplug the AC power cord and then plug it in again.
50
<ARE7108>
En