Inspect And Plan - U-Line Echelon CO2175DWR Installation Manual

General Precautions
Use this appliance for its intended purpose only and follow
these general precautions along with those listed throughout
this guide:
WARNING
—
SHOCK HAZARD Electrical Grounding Required.
• Keep the unit unplugged throughout installation
except during testing.
• Never remove the round grounding prong from the
plug and never use a two-prong grounding adapter.
• Never use an extension cord to connect power to
the unit.
• Always keep your working area dry.
WARNING
The Anti-Tip Kit must be installed on this unit before
it is used. Never use the drawers as steps or as a
shelf to support more than the drawers' contents.
Serious personal injury could occur.
CAUTION
• Use care when moving and handling the unit. Use gloves
to prevent personal injury from sharp edges.
• Do not lift the unit by the drawer handle.
• Do not install the unit behind closed doors or in any way
that would obstruct airflow to the front grille, which may
cause the unit to malfunction.
06/2006
CO2175DWR — Ice Maker/Refrigerator

2 Inspect and Plan

You have received a carton containing your CO2175DWR
Combo Drawer Model Ice Maker/Refrigerator with a
package inside containing a Use and Care Guide, a Product
Registration Card, water connection parts and Anti-Tip Kit.
Complete and mail the Product Registration Card or
register online at www.U-LineService.com. Once your unit is
installed, keep the Use and Care Guide and this Installation
Guide in a safe place for future reference.
Your unit is Black or Stainless Steel. Black units have drawers
with top handles designed for the installation of full overlay
drawer panels. When full overlay panels will not be used,
replacement handles MUST be installed (part number 26070-
01). Stainless Steel units have drawers with seamless full wrap
stainless steel fronts (that do
not accept custom panels), sculpted stainless steel handles
and black vinyl-clad cabinets. Please carefully follow the
directions that apply to your unit and your intended design.
Tools/Materials Required
• Wrenches
• Screwdrivers — slotted and Phillips head
• 1/4-inch OD copper tubing and shut-off valve for water
supply line
• 1/4-inch thick drawer panel material and cutting tools
(Black units) (IF using a 1/4" Panel)
• 3/4-inch thick drawer panel overlay material, cutting tools,
drill and bits (Black units) (If using 3/4" Overlay)
Inspection
Unwrap and inspect the unit on a flat, level surface capable
of supporting its entire weight.
Removing Protective Coating
All Models:
The protective coating covering the inside of the top drawer
must be removed before using.
Stainless Steel Models:
When inspecting/installing a Stainless Steel unit, the
protective coating covering the drawer fronts must be
removed. Start at a corner of the drawers and pull back the
protective coating to remove it from the drawer fronts.
After all the protective coating has been removed from the
drawers, clean all Stainless Steel surfaces with Claire Stainless
Steel Polish and Cleaner or comparable product or a mild
detergent and warm water solution and soft cloth. Do NOT
use abrasive cleaning agents.
Note: If cleaning with mild detergent and warm water
solution and soft cloth, the unit MUST be treated with Claire
Stainless Steel Polish and Cleaner or comparable product to
prevent discoloration.
3 www.U-LineService.com