Start-Up Troubleshooting - U-Line Echelon CO2175DWR Installation Manual

Electronic Control Panel
The electronic control with digital display (Figure 31) is
located in the top drawer. It is configured to show a single
temperature continuously. This set-point temperature is a
base number used by the controller to maintain the
temperature zone in your unit. The factory set-point is
38°F for the top drawer which will show when the unit is
first powered up. The factory set point for the ice
compartment is 0°F.
1 2
Figure 31
Other Settings
Other settings for the unit are factory preset. No adjustments
should be necessary at this time. See the Use and Care Guide
for information on:
• Removing the upper drawer's storage bin
• Removing the lower drawer's ice bucket
• Adjusting the upper drawer's organizer, left-to-right or
front-to-back
www.U-LineService.com
CO2175DWR — Ice Maker/Refrigerator
3 4 5
ULIN_0058_A

Start-Up Troubleshooting

Q:
Problem
Unit does not appear to turn on when POWER icon is
pressed.
A:
Solution
Make sure unit is plugged in and outlet has power (circuit
breaker has not tripped).
Q:
Problem
Water does not appear to be flowing into unit.
A:
Solution
Check that the water is connected and turned on and the
line is not obstructed. Remember that the ice maker
mechanism will not fill the mold with water until the
mold reaches the proper temperature.
Q:
Problem
The cubes produced during the first two to three hours of
operation have been discarded. New cubes still appear
cloudy.
A:
Solution
This is normal and is caused by air being trapped in the
cube during fast freezing.
See the Use and Care Guide's Troubleshooting Guide for
more solutions.
16
IMPORTANT
06/2006