Table of Contents
Advertisement
Chapter 16
4. Click SAVE.
Note: If you have set the Port Forwarding, DMZ or DHCP address reservation, and the new LAN IP address is not in the
same subnet with the old one, then you should reconfigure these features.
16 3
Set Up Link Aggregation
The Link Aggregation feature combines two ports together to make a single
highbandwidth data path, thus sustaining a higher-speed and more stable wired
network.
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to
Advanced
>
3. Enable
Link
Aggregation.
Note: To avoid LAN port conflicts, Link Aggregation and IPTV/VLAN cannot be enabled at the same time.
4. Select the
Mode
according to your need. It's recommended that you select the same
link aggregation mode for both ends of the link.
• Static
LAG: The member ports are manually added to the LAG. It is recommended
for a simple home network.
•
LACP: The router uses LACP to implement dynamic link aggregation and
disaggregation by exchanging LACP packets with its peer device. LACP
extends the flexibility of the LAG configuration. It is recommended for a
complex network.
5. Select the
Ports
that Link Aggregation will take effect, and click SAVE.
16 4
Flow Controller
With
Flow Controller
frame to notify the peer device to stop sending data for a specified period of time, thus
avoiding the packet loss caused by congestion.
Network
> LAN, and locate the
enabled, when a device gets overloaded it will send a PAUSE
Customize Your Network Settings
Link Aggregation
section.
106
Advertisement
Table of Contents
