Table of Contents
Advertisement
Installation
Warning: This appliance must be
installed by an authorised service
person or qualified technician, according
to the instructions in this guide and in
compliance with the current local
regulations.
• Incorrect installation may cause harm
and damage, for which the manufacturer
accepts no responsibility and the
warranty will not be valid.
• Prior to installation, ensure that the local
distribution conditions (electricity voltage
and frequency) and the adjustments
of the appliance are compatible. The
adjustment conditions for this appliance
are stated on the label.
• The laws, ordinances, directives and
standards in force in the country of use
are to be followed (safety regulations,
proper recycling in accordance with the
regulations, etc.).
Safety instructions for the installer
After removing the packaging material
from the appliance and its accessories,
ensure that the appliance is not damaged.
If you suspect any damage, do not use it
and contact an authorised service person
or qualified technician immediately.
Make sure that there are no flammable
or combustible materials in the close
vicinity, such as curtains, oil, cloth etc.
which may catch fire.
The worktop and furniture surrounding
the appliance must be made of materials
resistant to temperatures above 100°C.
If a cooker hood or cupboard is to be
All manuals and user guides at all-guides.com
installed above the appliance, the safety
distance between cooktop and any
cupboard/cooker hood should be as
shown below.
Minimum
42 cm
HOB
The appliance should not be installed
directly above a dishwasher, fridge,
freezer, washing machine or clothes dryer.
Power connection
Before connecting, check that the nominal volt-
age of the appliance, that is, the voltage stated
on the rating plate, corresponds to the available
supply voltage. The rating plate is located on
the lower casing of the hob.
Shut off power to circuit before connecting
wires to circuit.
The heating element voltage is AC230 V~. The
appliance also works perfectly on older net-
works with AC220 V~.
The hob is to be connected to the mains using
a device that allows the appliance to be dis-
connected from the mains at all poles with a
contact opening width of at least 3 mm, eg. au-
tomatic line protecting cut - out, earth leakage
trips or fuse.
A type H05VV-F cable or one of a higher grade
must be used as the mains connecting cable.
Rated current of
appliance (A)
Minimum
42 cm
Nominal
cross-sec-
tional area
(mm 2 )
English 11
Advertisement
Table of Contents
