Table of Contents
Advertisement
3. Remove
the
axle holder
nuts
(3) and
washers (4) from both sides then remove
the front wheel.
NOTE:
* Do not depress the brake lever when the
wheel is off the motorcycle. The caliper
piston will be forced out of the cylinder
with subsequent loss of brake fluid. If this
occurs, servicing of the brake system will
be necessary. See your authorized Honda
dealer for this service.
(3) Axle holder nut
(4) Washer
74
Installation Notes:
Set the axle in the axle holders.
Install the washer and axle holder nuts to
specified torque.
Axle holder nut torque:
59 N-m (5.9 kg-m,
43 I!b-ft)
Fit the caliper over the disc, taking care not
to damage the brake pads. Install the caliper
fixing bolts, and tighten to a torque of :
31
N-m (3.1
kg-m, 22 Ib-ft)
CAUTION:
¢ When
installing the wheel,
carefully
fit the brake disc between the brake
pads to avoid damaging the pads.
Advertisement
Table of Contents
