Table of Contents
Advertisement
2-5. INSTALLING OR
REPLACING
FLUORESCENT LAMPS
Figure 2-7
2-6. LOCATION
1004
This lamp has been designed to resist breakage and must be
replaced with Promolux part #12521C (Henny Penny part
#BL01-019) in order to maintain compliance with NSF stan-
dards. Use max. 21 watt, T5 Fluorescent lamp.
1. Make sure electrical power is off to unit and allow unit to cool.
To avoid electrical shock and burns, disconnect power and
allow unit to cool before changing lamp.
2. Using a Phillip's head screwdriver, remove the screws securing the
lamp retainers and remove retainers. Figure 2-7.
3. If replacing a faulty lamp, carefully rotate lamp out of sockets.
4. Install new lamp by carefully rotating the lamp into the socket and
snapping them into place. Repeat for each shelf.
5. Reinstall lamp retainers, restore power and unit is ready for opera-
tion.
The unit should be placed in an area where the unit can be loaded and
unloaded easily. For proper operation, the cabinet must be level.
If the Henny Penny heated express cabinet does not have legs, level the
unit and run a bead of silicone rubber (silicone or equivalent sealant
must be a NSF listed material) around the perimeter of the unit, sealing
it to the floor.
Model HEC-103/104/123/124
2-5
Advertisement
Table of Contents
