Table of Contents
Advertisement
2-2. UNPACKING
(Continued)
Figure 2-1
Figure 2-2
Figure 2-3
Figure 2-4
2-2
6A. Unpack and install shelves.
a. Hook the shelf brackets in the slots in the back, interior of unit.
See next pages (Figure 2-5 & 2-6) for proper slot arrangement for
either 2, 3 or 4 shelf units.
b. Pull the cover off the receptacles on each side of the shelves.
Figure 2-1.
c. Line up the prongs on the plug with the holes in the receptacle,
and firmly push the plugs into the receptacles. Figure 2-2.
The plugs must fit firmly into the receptacles for the lights and shelf
heaters to operate.
6B. CE UNITS-Upack and install shelves.
a. Hook the shelf brackets in the slots in the back, interior of unit.
See next pages (Figure 2-5 & 2-6) for proper slot arrangement for
either 2, 3 or 4 shelf units.
b. Using a Phillip's head screwdriver, remove the screw securing
the shelf plug cover and remove the cover. Figure 2-3.
c. Pull the cover off the receptacles on each side of the shelves.
Figure 2-1.
d. Line up the prongs on the plug with the holes in the receptacle,
and firmly push the plugs into the receptacles. Figure 2-2.
e. Insert the tab on the shelf plug cover into the slot on the back
panel and secure the cover in place using the screw previously
removed. Figure 2-4.
7. Install fluorescent lamps. See Installing or Replacing Fluorescent
Lamps Section.
8. Remove the bottom inserts and pull cardboard packing from around
elements in bottom of unit.
To avoid fire, remove the 3 corrugated shipping supports
located beneath these inserts, all visible packing material, tape,
and the unpacking instructions, prior to operation.
9. Peel off any protective covering from the exterior of the cabinet.
Take care when moving the cabinet to prevent personal
injury.
10. Once the shelves and shelf lamps are installed, and the packing
material removed, the unit is ready for operation.
Model HEC-103/104/123/124
705
Advertisement
Table of Contents
