Kenmore AquaLITE HF5010 Use & Care Manual page 17

USING YOUR HARD FLOOR WET/DRY VACUUM
7. Once you have completed
cleaning, press the power
button to stop the hard floor
cleaner and put the hard floor
cleaner back in the upright
position.
NOTE:
After pressing the
power button, the brush roller
stops immediately. The cleaner
still keeps on to vacuum dirty
water on the floor. The cleaner
will shut off after 3 seconds.
EMPTYING THE DIRTY WATER TANK
Empty the dirty water tank when
the DWT full indicator flashes.
During normal use, debris may
accumulate in the dirty water
tank. For best performance,
empty and rinse the dirty water
tank after each use. Never operate
the hard floor cleaner without
the dirty water tank and filter in
place.
Before emptying the dirty water
tank, ensure the appliance is
turned off.
CLEANER
Storage Base
- 17 -
8. Place the hard floor cleaner
back onto the storage base to
charge and air dry brush roller.
WARNING
• Do not vacuum foamed liquid.
• This hard floor cleaner is to be
used on indoor hard floors only,
such as vinyl, tile, sealed wood,
etc. Use on a rough surface may
not get the best performance.
• During operation, make sure
the water level in the DWT does
not exceed the Max line.
• To vacuum water left on the
surface, the hard floor cleaner
will switch off in 3 seconds after
power off.
1. Remove the dirty water tank
(DWT) from the hard floor
cleaner by pressing the dirty
water tank release button.
Dirty Water
Tank Release
Button