Advertisement
9.
Attach a Roller (39) and two 5/16" Washers (90)
between the indicated set of holes in the Squat
Slider (38) with a 5/16" x 3 112"Bolt (94), two 5/16"
Washers (90), and a 5/16" Nylon Locknut (86) as
shown.
Assemble
the other three Rollers (39) to the
Squat Slider (38) in the same manner,
10. Slide the Squat Slider (38) down onto the Squat
Updght (4).
11. Insertthe ends of two Weight Guides (42) intothe
indicatedbracket on the Long Base (120). Slide two
Weight Bumpers (49) ontothe Weight Guides. Next,
slideten Weights (44) ontothe Weight Guides. Make
sure that the Weights are turned so the grooved
sides of the Weights are facing downward,
Press a Weight Tube Bumper (48) into the lower
end of a Weight Tube (43). Insert the Weight Tube
into the centers of the Weights (44). Make sure
that the Weight Tube is turned as shown.
Lubricate the two outer holes in a Top Weight (45).
Slide the Top Weight onto the Weight Guides (42).
Make sure that the Top Weight is turned so the
grooved side is facing downward.
Apply a number "10" decal to the Top Weight (45) in
the locationshown. Apply decals with the numbers
20 through 110 to the ten Weights (44).
Assemble
the other weight stack in the same
way,
10
39
3
.-
6
90---_r_39
9
Advertisement
