Advertisement
53. Wrap the Squat Cable (73) under a 3 1/2" Pulley
(78). Attach the Pulley and a Cable Trap to the sec-
ond set of holes from the top in the indicated brack-
et on the Long Base (120) with a 3/8" x 2" Bolt
(100) and a 3/8" Nylon Locknut(87). Make sure
that the Cable Trap Is turned to hold the Cable
in the groove of the Pulley.
54. Wrap the Squat Cable (73) over a 4 1/2" Pulley
(119). Attach the Pulley to the indicated bracket on
the Top Frame (6) with a 3/8" x 1 3/4" Bolt (93) and
a 3/8" Nylon Locknut (87).
55. Place a 1/2" Washer (1) on top of the Weight Tube
(43) closestto the Squat Upright(4). Tighten a 1/2"
Nut (118) halfway onto the end of the Squat Cable
(73).
Lift the Weight Tube (43) and the Top Weight (45)
and make sure that the small pin on the Weight
Tube is inside of the groove under the Top Weight.
Hold the Weight Tube (43) and the Top Weight (45)
a few inches over the weight stack and insertthe
Weight Pin (50). Screw the end of the Cable (73)
two full turns intothe Weight Tube. Then, tightenthe
Nut against the 1/2" Washer (1). Remove the Weight
Pin and set the Top Weight back on the weight
stack. Replace the Pin.
56. Locate and open the parts bag labeled "SEAT
ASSEMBLY."
Insert the Pad Tube (23) intothe square hole in the
Seat Upright (9). Slide the two Knee Pads (19) onto
the Pad Tube as shown. Press the two Knee Pad
Caps (109) into the ends of the Pad Tube.
Slide two Short Pads (20) onto the Leg Lever (10).
100
120
87
19
73
56
1
20
10
109
19
Advertisement
