Roland HP 3700 Owner's Manual page 6

How to assemble the KS-2700 Roland piano Stand optional for the HP-2700
© You will need a coin to tighten the screws.
© Assembly will be easier if done by two people.
<Check the parts>
© Before you begin assembly, check that you have
all the parts.
® Side board (left) 0
Side board (right) ... ests
© Pedal board .......... ee
@) Center board oo... eee
@ Short screws (M4 x 30 mm) .. 4 yy
@ Long screws (M6 x 60 mm) ... 4 D
@ Connecting screws .. ee 4 @
@ Philips screwdriver ................ 1 @ a @
4 Ps "
<Assembly procedure >
Attach the side boards to the Fasten the pedal cable and plug in
1 pedal board. By the power cable and pedal cable.
x Extend the pedal cable out from the pedal board.
Note:
Be sure that the side
boards are oriented The metal fittings on the inside.
correctly: the metal
fittings are on the
inside.
@ Fasten the pedal cable
using the cable clamps
{three locations) on
the left side of the
stand.
@ Plug the pedal cable
into the bottom panel
fi of the piano.
(O) one the long ews
x 60 mm) to
@ Plug the power cable
fasten the side into the back panel of
boards to the pedal the piano.
e
board (use two —
The power cable is
screws for each side). incuded with the
2 Attach the center board. as
Pz
5 Adjust the adjusting bolt.
vx When you finish assembling the stand, rotate the
adjusting bolt until it touches the floor.
Note: If the piano is placed on carpeting, rotate the adjustment bolt little
@) Use the short screws (M4 x
more.
30 mm) to attach the center
board to the side boards
{use two screws for each
side).
3% Attach the piano to the stand.
Note: When placing the piano on the stand, be careful not to pinch your
fingers. (Avoid holding the
ends of the piano.)
Note: When placing the piano in its location, be careful not to pinch the
power cable underneath the piano.
(@ Align the screws (one
on each side) located
on the bottom of the
piano with the slots in
the metal fittings on
the side boards. Slide
the piano so the screws
slide into the slots.
p @ After securing the
piano to the metal
fittings of the side
boards, insert the
connecting screws
into the bottom of
@ Rotate the
adjusting bolt
until it touches
the floor. (Rotate
it to the right to
touch the floor,
and to the left to
retract.)
the piano through
the holes in metal
fittings.
3) Use a coin to
@ tighten the
connecting screws,
locking the piano
to the stand.