Roland HP 3700 Owner's Manual page 11

Precision Adjustment of |
(Master Tuning)
the Pitch
Using the Tuning knob located at the rear of
the instrument, the pitch can be adjusted so it
matches that of some other instrument.
A: 440Hz
(—50 Cent) b # (+50 Cent)
With the knob at its center position, the center A key on
the keyboard will have a frequency of 440 Hz.
Connecting External Devices
@ To connect other sound producing devices and have
their sound output from this instrument's speakers:
Use audio cables to make connection between the out-
put jacks on the device you wish to connect, such as a
rhythm machine (CR-1000/TR-626) or external sound
module (MT-100/RA-50), and the INPUT jacks on this in-
strument.
@ When you wish to have this instrument's sound be
played through other external speakers:
Using audio cable, make connections between the
input jacks on the audio set, amplifier, or mixer, and
the OUTPUT jacks on this instrument.
OUTPUT Jacks
INPUT Jacks
[Steps to Take to Make the Connections]
@ Turn down the volume on both this instrument and
the unit you intend to connect.
@ Turn the power OFF on both this instrument and the
unit you intend to connect.
@ Make the cable connections between this instrument
and the unit you are connecting with it.
@ Turn the power ON on both this instrument and the
unit you have connected.
@® Adjust the volume on both this instrument and the
unit you have connected to an appropriate level.
* if you do not wish to have sound come from this instrument's
speakers, use headphones.
1. Getting Started
Turning the Beckup Mode On
and Off |
Once the Backup Mode is turned on, the status
of everything set on the panel (excluding set-
tings related to the Demo mode) is remem-
bered. This way, the next time you turn power
on the same settings profile will be in effect.
You thus do not have to be troubled with
making the settings you prefer each time power
is turned on.
If the Backup Mode is set to "Off," the instru-
ment will return to the factory default settings
the next time power is turned on.
Procedure for Turning ON the Backup Mode
While holding down both the KEY TRANS-
POSE and TEMPERAMENT buttons, turn the
power ON.
Thereafter, the settings for all functions will
ceeteise in memory, even while power is
fo)
KEY TEMPERA-
TRANSPOSE MENT ROWER
Hold down — turn On
Procedure for Turning OFF the Backup Mode
While holding down both the A and ¥ but-
tons for VALUE, turn the power ON. Each
time power is turned on, all settings will be
set at their factory defaults.
VALUE
y A
b yA FY
i
Hold down turn On
* This instrument is equipped with a backup-use
battery which serves, when the Backup Mode is
"on," in maintaining the contents of memory
while power is turned off. This battery should,
as a rule, be changed every 5 years. (The actual
lifetime of the battery may vary depending on
the conditions of use.) When it is time to replace
the battery, check with your nearest Roland
Service Station.
POWER