Roland HP 3700 Owner's Manual page 5

Optional for the HP-3700
% Attach the piano to the stand.
Note:
When placing the piano on
the stand, be careful not to
pinch your fingers. (Avoid
holding the ends of the
piano.
@ Insert the two connecting screws (one
on each side) through the holes in the
metal fittings of the side boards into
the screw holes on the bottom of the
piano.
@FPlug the pedal cable
into the bottom of the
piano.
@ Align the screws (one
on each side) on the
bottom of the piano
with the slots in the
metal fittings of the
side boards, slide the
piano towards the rear.
ay Attach the rear board.
Note:
When attaching the rear board, be careful
not to pinch the pedal cable.
@ Use a coin to tighten the connecting
screws, locking the piano to the
stand.
Note:
The screw holes in the rear board are
sunken on the out side to accomodate the
screw head.
ame
outside —_ inside
@ Insert the holes of the rear board into
the screws of the side board (6
locations), press down into place, and
': tighten the screws.
5 Attach the side covers.
at wide
Note:
Be sure that the side covers
are oriented correctly.
(The rims of the side covers
are wider at the back.)
" narrow
@ Use the long screws (M6 x
60 mm) to fasten the side
covers in place from the
Lb inside (two screws for each
" narrow side).
Attach the AC cable and adjust the adjusting bolt.
vz When you finish assembling the stand, attach the
power cable (included with the piano), and rotate
the adjusting bolt until it touches the floor.
Note:
If the piano is placed on carpeting, rotate
the adjustment bolt a little more.
Note:
When placing the piano in its location, be
sure not to pinch the AC cable underneath
@ Rotate the adjusting
the piano.
bolt until it touches
the floor. (Rotate it to
the right to touch the
floor, and to the left to
retract.)