Initial Settings - Danfoss ECtemp Next Plus Installation Manual

Danfoss ECtemp Next Plus
4.2

Initial Settings

Initial settings must be speci ed when the unit is activated
for the rst time:
Press M button for 6 seconds to enter the parameter setting
mode.
The upper digits indicate the parameter number.
Press M for parameter selection.
Press < or > to set the parameter range.
Complete all adjustments.
Press to exit ECtemp Next Plus settings, which is available
for this purpose.
To exit ECtemp Next settings automatic wait approx. 30
seconds.
The digits indicate the set value as follows:
No. Parameter settings
P01 Working mode
P02 Temperature control
mode
Installation Guide
Settings range
01: Manual
02: Advanced Program-
mable Timer
01: Room and oor temp;
02: Only oor temp.;
03: Only room temp.*
Default
02
01
9